3.5mm locking t plates

Designed for use with our 3.5mm locking screws, these plates also have a stacked feature, allowing the use of standard cortical or cortical self-tapping screws. Our T350766LOCK features three screw holes in the head section and four screw holes in the shaft section. Limited contact undercuts reduce the impact of these plates on underlying periosteal blood supply and reduce stress concentration at the screw-holes. The additional reduction hole at the proximal end of these plates will accept A-wires up to 1.8mm in diameter.
In stock
SKU
3.5-1016
3.5mm locking t plate 6 hole 60mm
(exclu. VAT)
SKU: T350660LOCK
3.5mm locking t plate 7 hole 66mm
(exclu. VAT)
SKU: T350766LOCK
3.5mm locking t plate 8 hole 80mm
(exclu. VAT)
SKU: T350880LOCK
3.5mm locking t plate 10 hole 100mm
(exclu. VAT)
SKU: T3510100LOCK
3.5mm locking t plate 12 hole 120mm
(exclu. VAT)
SKU: T3512120LOCK
Locking constructs offer inherently better angular stability than non-locking constructs. This can be useful when managing small fragments where only a low screw count is possible, such as with distal radial fractures, and corrective osteotomies or wedge ostectomies positioned towards the end of a bone. Precise contouring is less important compared with non-locking implants as the underside of the plate does not need to sit flat on the surface of the bone. This can help save significant time in theatre. Stepping the plate off from the bone surface or positioning it at a slight angle to the bone surface can be used to good advantage when correcting angular limb deformities; the cortices do not re-align into an undesired position as screws are tightened.